SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|2||$46.80||  ADD TO CART|
1.1 This test method covers determination of ductility utilizing Epstein test strips and a bending device for bending the strip over a predetermined radius. It is intended for commercial silicon-bearing steel sheet or strip of nonoriented types in the thickness range from 0.010 to 0.031 in. [0.25 to 0.79 mm], inclusive.
1.2 The values and equations stated in customary (cgs-emu and inch-pound) or SI units are to be regarded separately as standard. Within this test method, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this test method.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A34/A34M Practice for Sampling and Procurement Testing of Magnetic Materials
A677 Specification for Nonoriented Electrical Steel Fully Processed Types
A683/A683M Specification for Nonoriented Electrical Steel, Semiprocessed Types
E290 Test Methods for Bend Testing of Material for Ductility
ICS Number Code 77.140.50 (Flat steel products and semi-products)
UNSPSC Code 31380000(Magnets and magnetic materials)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM A720 / A720M-02, Standard Test Method for Ductility of Nonoriented Electrical Steel, ASTM International, West Conshohocken, PA, 2002, www.astm.orgBack to Top