ASTM A710/A710M-00

    Standard Specification for Age-Hardening Low-Carbon Nickel-Copper-Chromium-Molybdenum-Columbium Alloy Structural Steel Plates

    SUPERSEDED (see Active link, below)

      Format Pages Price  
    PDF 3 $44.40   ADD TO CART

    1. Scope

    1.1 This specification covers low-carbon age-hardening nickel - copper - chromium - molybdenum - columbium alloy steel plates for general applications.

    1.2 One grade with three different conditions is provided as follows:

    Grade and ClassCondition
    Grade A, Class 1 as-rolled and precipitation heat treated
    Grade A, Class 2normalized and precipitation heat treated
    Grade A, Class 3 quenched and precipitation heat treated

    1.3 Grade A provides minimum yield strength levels ranging from 50 to 85 ksi [345 to 585 MPa], depending on thickness and condition.

    1.4 Grade A, Class 1, plates are limited to a maximum thickness of 3/4 in. [20 mm]. The maximum thickness of Grade A, Classes 2 and 3, is limited only by the capacity of the composition to meet the specified mechanical property requirements; however, current practice normally limits the maximum thickness to 8 in. [200 mm].

    1.5 Mandatory notch toughness requirements are specified for Grade A, Class 1.

    1.6 When the steel is to be welded, it is presupposed that a welding procedure suitable for the grade of steel and intended use or service will be utilized. See Appendix X3 of Specification A6/A6M for information on weldability.

    1.7 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A6/A6M Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling

    A673/A673M Specification for Sampling Procedure for Impact Testing of Structural Steel

    ICS Code

    ICS Number Code 77.080.20 (Steels)

    UNSPSC Code

    UNSPSC Code 30102204(Steel plate)

    DOI: 10.1520/A0710_A0710M-00

    ASTM International is a member of CrossRef.

    Citing ASTM Standards
    Back to Top