1.1 This specification covers material in mat (or sheet) form fabricated from hot-rolled, plain steel bars or rods to be used for the reinforcement of concrete. Mats consist of two layers of bars or rods which are assembled by welding at right angles to each other.
1.2 This specification is applicable for orders in either inch-pound units (as A 704) or in SI units [as A 704M].
1.3 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A185/A185M Specification for Steel Welded Wire Reinforcement, Plain, for Concrete
A497/A497M Specification for Steel Welded Wire Reinforcement, Deformed, for Concrete
A615/A615M Specification for Deformed and Plain Carbon-Steel Bars for Concrete Reinforcement
A700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment
A706/A706M Specification for Low-Alloy Steel Deformed and Plain Bars for Concrete Reinforcement
U.S. Military Standard
MIL-STD-29 Marking for Shipment and Storage
U.S. Federal Standard
concrete reinforcement; mats; steel bars; steel rods: Concrete reinforcement--specifications; Steel bars (concrete reinforcement- specifications); Welded steel bars/shapes--specifications;
ICS Number Code 77.140.15 (Steels for reinforcement of concrete)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]