1.1 This specification covers steel fence posts and assemblies manufactured from hot-wrought sections and intended for use in field and line fencing.
1.2 The posts are available in tee, channel, or U and Y-bar shapes or angle shapes and are furnished painted or galvanized, unless otherwise specified.
1.3 The values stated in inch-pound units are to be regarded as the standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A29/A29M Specification for Steel Bars, Carbon and Alloy, Hot-Wrought, General Requirements for
A36/A36M Specification for Carbon Structural Steel
A123/A123M Specification for Zinc (Hot-Dip Galvanized) Coatings on Iron and Steel Products
A153/A153M Specification for Zinc Coating (Hot-Dip) on Iron and Steel Hardware
A499 Specification for Steel Bars and Shapes, Carbon Rolled from T Rails
A641/A641M Specification for Zinc-Coated (Galvanized) Carbon Steel Wire
A700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment
FED-STD-123 Marking for Shipments (Civil Agencies) Available from Standardization Documents Order Desk, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.
MIL-STD-163 Steel Mill Products, Preparation for Shipment and Storage
hot wrought steel bars; steel bars;
ICS Number Code 77.140.85 (Iron and steel forgings)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]