ASTM A694/A694M-08

    Standard Specification for Carbon and Alloy Steel Forgings for Pipe Flanges, Fittings, Valves, and Parts for High-Pressure Transmission Service


      Format Pages Price  
    PDF 3 $45.60   ADD TO CART


    1. Scope

    1.1 This specification covers forged or rolled steel pipe flanges, forged fittings, valves, and parts suitable for use with high-strength transmission-service pipe. Included are flanges, fittings, and similar parts ordered either to dimensions specified by the purchaser or to ASME or MSS dimensional standards referenced in Section 2.

    1.2 Several grades of material, based on minimum yield strength requirements, are covered, as indicated in Table 1.

    1.3 Supplementary Requirements are provided. Supplementary Requirement S 1 is provided for use when purchaser approval is required for repair welding.

    1.4 This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable M specification designation (SI units), the material shall be furnished to inch-pound units.

    1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

    TABLE 1 Tensile Requirements

    Grade
    Yield Strength (0.2 % Offset), min, ksi [MPa]
    Tensile Strength,
    min, ksi [MPa]
    Elongation in 2 in. or 50 mm, min %
    F4242 [290]60 [415]20
    F4646 [315]60 [415]20
    F4848 [330]62 [425]20
    F5050 [345]64 [440]20
    F5252 [360]66 [455]20
    F5656 [385]68 [470]20
    F6060 [415]75 [515]20
    F6565 [450]77 [530]20
    F70 70 [485]82 [565]18


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A53/A53M Specification for Pipe, Steel, Black and Hot-Dipped, Zinc-Coated, Welded and Seamless

    A106/A106M Specification for Seamless Carbon Steel Pipe for High-Temperature Service

    A381 Specification for Metal-Arc-Welded Steel Pipe for Use With High-Pressure Transmission Systems

    A707/A707M Specification for Forged Carbon and Alloy Steel Flanges for Low-Temperature Service

    A788/A788M Specification for Steel Forgings, General Requirements

    A961/A961M Specification for Common Requirements for Steel Flanges, Forged Fittings, Valves, and Parts for Piping Applications


    ICS Code

    ICS Number Code 77.140.85 (Iron and steel forgings)

    UNSPSC Code

    UNSPSC Code 31132100(Steel forgings)


    Referencing This Standard

    DOI: 10.1520/A0694_A0694M-08

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM A694 / A694M-08, Standard Specification for Carbon and Alloy Steel Forgings for Pipe Flanges, Fittings, Valves, and Parts for High-Pressure Transmission Service, ASTM International, West Conshohocken, PA, 2008, www.astm.org

    Back to Top