ASTM A686-92(2004)

    Standard Specification for Tool Steel, Carbon

      Format Pages Price  
    PDF 12 $61.20   ADD TO CART

    1. Scope

    1.1 This specification covers the chemical, mechanical, and physical requirements for available wrought carbon tool steel products.

    1.2 These products, which include hot- or cold-finished bar, plate, sheet, rod, wire, or forgings, are normally fabricated into tools, dies, or fixtures. The selection of a material for a particular application will depend upon design, service conditions, and desired properties.

    1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A388/A388M Practice for Ultrasonic Examination of Steel Forgings

    A561 Practice for Macroetch Testing of Tool Steel Bars

    A700 Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment

    E3 Guide for Preparation of Metallographic Specimens

    E30 Test Methods for Chemical Analysis of Steel, Cast Iron, Open-Hearth Iron, and Wrought Iron

    E45 Test Methods for Determining the Inclusion Content of Steel

    E59 Practice for Sampling Steel and Iron for Determination of Chemical Composition

    Military Standard


    Federal Standards

    Fed. Std. No. 123 Marking for Shipment (Civil Agencies)

    Fed. Std. No. 183 Continuous Identification Marking of Iron and Steel Products

    ICS Code

    ICS Number Code 77.140.10 (Heat-treatable steels)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0686-92R04

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM A686-92(2004), Standard Specification for Tool Steel, Carbon, ASTM International, West Conshohocken, PA, 2004,

    Back to Top