ASTM A675/A675M-03e1

    Standard Specification for Steel Bars, Carbon, Hot-Wrought, Special Quality, Mechanical Properties

    SUPERSEDED (see Active link, below)

      Format Pages Price  
    PDF 5 $51.60   ADD TO CART

    1. Scope

    1.1 This specification covers hot-wrought special quality carbon steel bars and bar size shapes produced to mechanical property requirements and intended for general constructional applications.

    1.2 The bars are available in nine strength grades designated 45, 50, 55, 60, 65, 70, 75, 80, and 90 [310, 345, 380, 415, 450, 485, 515, 550, and 620] corresponding to the minimum ultimate tensile strength in ksi [MPa]. The chemical composition is selected by the manufacturer to develop the required mechanical properties.

    1.3 Hot-wrought special quality carbon steel bars subject to mechanical property requirements are hot wrought in straight lengths only. Sections and sizes available are covered in Specification A 29/A 29M.

    1.4 Some applications may require one or more of the available designations shown under Supplementary Requirements.

    Note 1—Merchant-quality hot-wrought carbon steel bars subject to mechanical property requirements are covered in Specification A 663/A 663M.

    1.5 The values stated in either inch-pound units or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system are not equivalents, therefore each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A29/A29M Specification for Steel Bars, Carbon and Alloy, Hot-Wrought, General Requirements for

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A663/A663M Specification for Steel Bars, Carbon, Merchant Quality, Mechanical Properties

    E290 Test Methods for Bend Testing of Material for Ductility

    ICS Code

    ICS Number Code 77.140.60 (Steel bars and rods)

    UNSPSC Code

    UNSPSC Code 30263600(Carbon steel bars)

    DOI: 10.1520/A0675_A0675M-03E01

    ASTM International is a member of CrossRef.

    Citing ASTM Standards
    Back to Top