1.1 This specification covers grades of stainless steel tubing in sizes under 1/2 down to 0.050 in. (12.7 to 1.27 mm) in outside diameter and wall thicknesses less than 0.065 in. down to 0.005 in. (1.65 to 0.13 mm) for general corrosion-resisting and low- or high-temperature service, as designated in Table 1.
Note 1—The grades of austenitic stainless steel tubing furnished in accordance with this specification have been found suitable for low-temperature service down to 325°F (200°C) in which Charpy notched-bar impact values of 15 ftlbf (20 J), minimum, are required and these grades need not be impact tested.
1.2 Optional supplementary requirements are provided and, when desired, shall be so stated in the order.
1.3 The values stated in inch-pound units are to be regarded as the standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A262 Practices for Detecting Susceptibility to Intergranular Attack in Austenitic Stainless Steels
A380 Practice for Cleaning, Descaling, and Passivation of Stainless Steel Parts, Equipment, and Systems
E165 Practice for Liquid Penetrant Examination for General Industry
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
SAE J 1086 Practice for Numbering Metals and Alloys (UNS) Available from SAE International (SAE), 400 Commonwealth Dr., Warrendale, PA 15096-0001, http://www.sae.org.
austenitic stainless steel; seamless tube; small diameter; stainless steel tube; steel tube; welded steel tube; Austenitic stainless steel tube--specifications; Corrosive service applications--tube (steel); Heavy-thickness steel coils--specifications; Hot-rolled steel sheet/strip--specifications; Stainless steel tube--specifications; Structural steel (SS) sheet/strip--specifications; Welded steel tube--specifications;
ICS Number Code 23.040.10 (Iron and steel pipes); 23.040.40 (Metal fittings)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]