SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|8||$52.80||  ADD TO CART|
1.1 These test methods include four methods for the determination of tin coating weights for electrolytic tin plate as follows:Test Method Sections A-Bendix Test Method 3 to 9 B-Constant-Current, Electrolytic Test Method (Referee Method) 10 to 22 C-Sellar's Test Method 23 to 32 D-Titration Test Method 33 to 41
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A599/A599M Specification for Tin Mill Products, Electrolytic Tin-Coated, Cold-Rolled Sheet
A623 Specification for Tin Mill Products, General Requirements
A623M Specification for Tin Mill Products, General Requirements [Metric]
A624/A624M Specification for Tin Mill Products, Electrolytic Tin Plate, Single Reduced
A626/A626M Specification for Tin Mill Products, Electrolytic Tin Plate, Double Reduced
D1125 Test Methods for Electrical Conductivity and Resistivity of Water
ICS Number Code 25.220.40 (Metallic coatings)
UNSPSC Code 73181108(Tin plating service)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM A630-98, Standard Test Methods for Determination of Tin Coating Weights for Electrolytic Tin Plate, ASTM International, West Conshohocken, PA, 1998, www.astm.orgBack to Top