1. Scope
1.1 These test methods include four methods for the determination of tin coating weights for electrolytic tin plate as follows:
| Test Method | Sections |
| A-Bendix Test Method | 3 to 9 |
| B-Constant-Current, Electrolytic Test Method (Referee Method) | 10 to 18 |
| C-Sellar's Test Method | 19 to 28 |
| D-Titration Test Method | 29 to 37 |
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A599/A599M Specification for Tin Mill Products, Electrolytic Tin-Coated, Cold-Rolled Sheet
A623 Specification for Tin Mill Products, General Requirements
A623M Specification for Tin Mill Products, General Requirements [Metric]
A624/A624M Specification for Tin Mill Products, Electrolytic Tin Plate, Single Reduced
A626/A626M Specification for Tin Mill Products, Electrolytic Tin Plate, Double Reduced
D1125 Test Methods for Electrical Conductivity and Resistivity of Water
Keywords
Bendix method; Coating weight; Constant-current electrolytic method; Electrolytic tin plate; Electrostripping; Hot-dip (galvanized) coatings; Instrumental measurement--metals/alloys; Referee methods; Sellar's method; Tin coating weights; Tin mill products; Titration;
ICS Code
ICS Number Code 25.220.40 (Metallic coatings)
DOI: 10.1520/A0630-03
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
