ASTM A625/A625M-03

    Standard Specification for Tin Mill Products, Black Plate, Single Reduced

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF Version 2 $44.40   ADD TO CART


    1. Scope

    1.1 This specification covers single-reduced black plate produced from low carbon, cold-reduced steel, furnished in coils and cut sizes, for use in the manufacture of containers, closures, signs, toys and other products, as well as for plating applications.

    1.2 It may be supplied dry or oiled and with or without surface treatment. This product is normally supplied with a trimmed edge.

    1.3 This specification is applicable to orders in either inch-pound units (as A 625), which is supplied in thicknesses from 128-lb base weight (0.0141 in.) and lighter, or SI units (as A 625M), which is supplied in thicknesses from 0.358 mm and lighter.

    1.4 The values stated in either inch-pound or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A623 Specification for Tin Mill Products, General Requirements

    A623M Specification for Tin Mill Products, General Requirements [Metric]


    ICS Code

    ICS Number Code 77.140.50 (Flat steel products and semi-products)

    UNSPSC Code

    UNSPSC Code 73181108(Tin plating service)


    DOI: 10.1520/A0625_A0625M-03

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top