ASTM A578/A578M-96(2001)

    Historical Standard: ASTM A578/A578M-96(2001) Standard Specification for Straight-Beam Ultrasonic Examination of Plain and Clad Steel Plates for Special Applications

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    5 pages
    $50.40

    Active (view current version of standard)


    ASTM A578 / A578M

    1. Scope

    1.1 This specification covers the procedure and acceptance standards for straight-beam, pulse-echo, ultrasonic examination of rolled carbon and alloy plain and clad steel plates, 3/8 in. [10 mm] in thickness and over, for special applications. The method will detect internal discontinuities parallel to the rolled surfaces. Three levels of acceptance standards are provided. Supplementary requirements are provided for examination of clad plate and for alternative procedures.

    1.2 Individuals performing examinations in accordance with this specification shall be qualified and certified in accordance with the requirements of the latest edition of ASNT SNT-TC-1A or an equivalent accepted standard. An equivalent standard is one which covers the qualification and certification of ultrasonic nondestructive examination candidates and which is acceptable to the purchaser.

    1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ANSI Standard

    B 46.1 Surface Texture

    ASTM Standards

    A263 Specification for Stainless Chromium Steel-Clad Plate

    A264 Specification for Stainless Chromium-Nickel Steel-Clad Plate

    A265 Specification for Nickel and Nickel-Base Alloy-Clad Steel Plate


    ICS Code

    ICS Number Code 77.040.20 (Non-destructive testing of metals)

    UNSPSC Code

    UNSPSC Code 30102204(Steel plate)


    DOI: 10.1520/A0578_A0578M-96R01

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top