1.1 This specification covers the requirements for quenched and tempered alloy steel socket-head cap screws
1.6 mm through 48 mm in diameter having a minimum ultimate tensile strength of 1220 MPa.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
E112 Test Methods for Determining Average Grain Size
F606M Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, and Rivets (Metric)
F788/F788M Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series
F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection
F1789 Terminology for F16 Mechanical Fasteners
F1940 Test Method for Process Control Verification to Prevent Hydrogen Embrittlement in Plated or Coated Fasteners
F2282 Specification for Quality Assurance Requirements for Carbon and Alloy Steel Wire, Rods, and Bars for Mechanical Fasteners
F2328M Test Method for Determining Decarburization and Carburization in Hardened and Tempered Threaded Steel Bolts, Screws and Studs (Metric)
alloy steel; cap screws; socket head; Alloy steel screws--specifications; Head cap screws; Hexagon socket screw; Screws--specifications; Steel screws--specifications
ICS Number Code 21.060.10 (Bolts, screws, studs)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]