ASTM A571/A571M-01(2006)

    Standard Specification for Austenitic Ductile Iron Castings for Pressure-Containing Parts Suitable for Low-Temperature Service


      Format Pages Price  
    PDF 5 $51.60   ADD TO CART


    1. Scope

    1.1 This specification covers austenitic ductile iron, Type D-2M, Classes 1 and 2, for compressors, expanders, pumps, valves, and other pressure-containing parts intended primarily for low-temperature service.

    1.2 These grades of austenitic ductile iron are characterized by having their graphite substantially in a spheroidal form and free of flake graphite. They are essentially free of carbides and contain sufficient alloy content to produce a stable austenitic matrix down to -423°F; [-252°C] (liquid hydrogen).

    1.3 The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

    The following precautionary caveat pertains only to the test methods portion, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A941 Terminology Relating to Steel, Stainless Steel, Related Alloys, and Ferroalloys

    E8 Test Methods for Tension Testing of Metallic Materials

    E23 Test Methods for Notched Bar Impact Testing of Metallic Materials

    E30 Test Methods for Chemical Analysis of Steel, Cast Iron, Open-Hearth Iron, and Wrought Iron

    E59 Practice for Sampling Steel and Iron for Determination of Chemical Composition


    ICS Code

    ICS Number Code 77.140.80 (Iron and steel castings)

    UNSPSC Code

    UNSPSC Code 31101618(Ductile iron sand casting)


    Referencing This Standard

    DOI: 10.1520/A0571_A0571M-01R06

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM A571 / A571M-01(2006), Standard Specification for Austenitic Ductile Iron Castings for Pressure-Containing Parts Suitable for Low-Temperature Service, ASTM International, West Conshohocken, PA, 2006, www.astm.org

    Back to Top