1.1 This specification covers hot-finished and cold-finished martensitic chromium steel bars for high-temperature service. The mechanical properties are developed by suitable heat treatment, as indicated for each alloy.
1.2 Where strength at temperature is a factor, these steels are generally limited to a maximum service temperature of 1200F [650C]. For oxidation (scaling) resistance and at low stresses, these steels are useful to 1450F [790C].
1.3 This specification is expressed in both inch-pound units and SI units; however, unless the purchase order or contract specifies the applicable M specification designation (SI units), the inch-pound units shall apply. The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A484/A484M Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings
A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
A994 Guide for Editorial Procedures and Form of Product Specifications for Steel, Stainless Steel, and Related Alloys
E112 Test Methods for Determining Average Grain Size
E292 Test Methods for Conducting Time-for-Rupture Notch Tension Tests of Materials
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
E562 Test Method for Determining Volume Fraction by Systematic Manual Point Count
SAEJ1086 Recommended Practice for Numbering Metals and Alloys (UNS)
martensitic stainless steel; stainless steel bars; stainless steel billets; stainless steel forgings; temperature service applicationshigh; Alloy steel sheet/strip--specifications; Bars/forging/forging stock--specifications; High-temperature service applications--steel bars; Hot-rolled steel sheet/strip--specifications; HSLA (high-strength low-alloy) steel bars--specifications; Martensitic stainless steel bars--specifications; Martensitic stainless steel forgings--specifications; Stainless steel bars/billets--specifications; Stainless steel forgings--specifications; Steel bars/forgings/forging stock--specifications ;
ICS Number Code 77.140.60 (Steel bars and rods); 77.140.85 (Iron and steel forgings)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]