1.1 This specification covers bars and shapes of age-hardening stainless steels. Hot-finished or cold-finished rounds, squares, hexagons, bar shapes, angles, tees, and channels are included; these shapes may be produced by hot rolling, extruding, or forging. Billets or bars for reforging may be purchased to this specification.
1.2 These steels are generally used for parts requiring corrosion resistance and high strength at room temperature, or at temperatures up to 600°F [315°C]; 700°F [370°C] for Type 632. They are suitable for machining in the solution-annealed condition after which they may be age-hardened to the mechanical properties specified in Section 7 without danger of cracking or distortion. Type XM-25 is machinable in the as-received fully heat treated condition.
1.3 Types 631 and 632 contain a large amount of ferrite in the microstructure and can have low ductility in forgings and larger diameter bars. Applications should be limited to small diameter bar.
1.4 The values stated in either inch-pound units or SI (metric) units are to be regarded separately as standards; within the text and tables, the SI units are shown in [brackets]. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.
1.5 Unless the order specifies an "M'' designation, the material shall be furnished to inch-pound units.
Note 1—For forgings, see Specification A 705/A 705M.
Note 2—For billets and bars for forging see Specification A 314.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A314 Specification for Stainless Steel Billets and Bars for Forging
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A484/A484M Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings
A705/A705M Specification for Age-Hardening Stainless Steel Forgings
A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
SAEJ1086 Recommended Practice for Numbering Metals and Alloys (UNS) Available from Society of Automotive Engineers (SAE), 400 Commonwealth Dr., Warrendale, PA 15096-0001, http://www.sae.org.
age-hardening stainless steel; precipitation hardening stainless steel; stainless steel bars; stainless steel shapes; Age-hardening alloys--specifications; Cold-finished steel bars--specifications; Corrosive service applications--bars/rods/shapes; High-temperature service applications--steel bars; Hot-rolled stainless steel bars--specifications; Precipitation-hardening metals/alloys--specifications; Stainless steel bars/billets--specifications; Steel bars and shapes--specifications; Steel bars/shapes/wires; Udimet alloy;
ICS Number Code 77.140.60 (Steel bars and rods); 77.140.70 (Steel profiles)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]