1.1 This specification covers carbon steel plates intended primarily for service in welded pressure vessels where improved notch toughness is important.
1.2 Plates under this specification are available in four grades having different strength levels as follows:
| Grade U.S. [SI] || Tensile Strength,ksi [MPa]|
|55 ||55-75 [380-515]|
|60 ||60-80 [415-550]|
|65 ||65-85 [450-585]|
|70 ||70-90 [485-620] |
1.3 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements; however, current practice normally limits the maximum thickness of plates furnished under this specification as follows:
| Grade U.S. [SI] || Maximum Thickness,in. [mm]|
|55 ||12 |
|60 ||8 |
|65 ||8 |
|70 ||8  |
1.4 For plates produced from coil and furnished without heat treatment or with stress relieving only, the additional requirements, including additional testing requirements and the reporting of additional test results of Specification A 20/A 20M apply.
1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A20/A20M Specification for General Requirements for Steel Plates for Pressure Vessels
A435/A435M Specification for Straight-Beam Ultrasonic Examination of Steel Plates
A577/A577M Specification for Ultrasonic Angle-Beam Examination of Steel Plates
A578/A578M Specification for Straight-Beam Ultrasonic Examination of Rolled Steel Plates for Special Applications
carbon steel; carbon steel plate; pressure containing parts; pressure vessel steels; steel plates for pressure vessels; Carbon steel plate--specifications; Low-temperature service applications--steel plate; Moderate-temperature service applications--steel plate; Welded steel plate/sheet/strip--specifications;
ICS Number Code 77.140.30 (Steels for pressure purposes)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]