1.1 This specification covers three grades of steel rivets in diameters from 1/2 to 1 1/2 in. inclusive, for structural fabricating purposes. The grades are as follows:
|1||Carbon steel rivets for general purpose use|
|2||Carbon manganese steel rivets for use with high strength carbon and high strength low alloy structural steels |
|3||Weathering steel rivets|
1.2 The values stated in inch-pound units are to be regarded as the standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
D3951 Practice for Commercial Packaging
F606 Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets
F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection
G101 Guide for Estimating the Atmospheric Corrosion Resistance of Low-Alloy Steels
B 18.1.2 Large Rivets (12 Inch Nominal Diameter and Larger) Available from American Society of Mechanical Engineers (ASME), ASME International Headquarters, Three Park Ave., New York, NY 10016-5990, http://www.asme.org.
carbon steel; rivets; steel; structural ; weathering steel; Rivets--specifications; Strucutural steel rivets--specifications;
ICS Number Code 21.060.40 (Rivets)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]