ASTM A496-97ae1

    Historical Standard: ASTM A496-97ae1 Standard Specification for Steel Wire, Deformed, for Concrete Reinforcement

    SUPERSEDED


    Buy Standard (PDF)
    5 pages
    $50.40


    1. Scope

    1.1 This specification covers deformed steel wire which has been cold-worked by drawing, rolling, or both drawing and rolling, to be used as produced, or in fabricated form, for the reinforcement of concrete in sizes having nominal cross-sectional areas not less than 6.45 mm 2 (0.01 in.2).

    1.2 Supplement S1 describes high-strength wire, which shall be furnished when specifically ordered. It shall be permissible to furnish high-strength wire in place of regular wire if mutually agreed to by the purchaser and supplier.

    1.3 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text the inch-pound units are shown in brackets. The value stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values may result in nonconformance with the specification.


    ICS Code

    ICS Number Code 77.140.15 (Steels for reinforcement of concrete)

    UNSPSC Code

    UNSPSC Code 30111900(Concrete reinforcement hardware)


    DOI: 10.1520/A0496-97AE01

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top