1. Scope
1.1 This specification covers weldless forged, quenched, and tempered carbon steel threaded lifting eyes (formerly eyebolts) for overhead lifting.
Note 1—Lifting eyes carrying this specification number even though they are liquid quenched and tempered may be processed from carbon steel which, in the composition range permitted by this specification, could have a fracture appearance transition temperature (50 % shear) higher than operating temperatures. Therefore, in order to minimize the possibility of a brittle cleavage failure, these lifting eyes should never be loaded above the proof load, and should not be used when surface discontinuities exist on the lifting eyes.
1.2 The specification includes two types denoting shank pattern and one style denoting shank length (both defined in ASME B 18.15) as follows:
1.2.1 Type 1—Plain pattern (straight shank).
1.2.2 Type 2—Shoulder pattern.
1.2.3 Style B—Short length.
1.3 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only.
1.4 Terms used in this specification are defined in Terminology F 1789 unless otherwise defined herein.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
E112 Test Methods for Determining Average Grain Size
F606 Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets
F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection
F1789 Terminology for F16 Mechanical Fasteners
ASME Standards
B 18.24 Part Identifying Number (PIN) Code System Standard for Fastener Products
Keywords
carbon steel; eyebolts; lifting eye; steel; Carbon steel bolting materials--specifications; Eyebolts (steel); Lifting eyes; Overhead lifting
ICS Code
ICS Number Code 21.060.10 (Bolts, screws, studs)
DOI: 10.1520/A0489-04E01
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
