SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|13||$60.00||  ADD TO CART|
1.1 This specification2 covers general requirements that shall apply to wrought stainless steel bars, shapes, forgings, and billets or other semi-finished material (except wire) for forging, under the latest revision of each of the following ASTM specifications: A276, A314, A458, A473, A477, A479/A479M, A564/A564M, A565/A565M, A582/A582M, A638/A638M, A705/A705M, and A831/A831M.
1.2 In the case of conflict between a requirement of a product specification and a requirement of this specification, the product specification shall prevail. In the case of conflict between a requirement of the product specification or a requirement of this specification and a more stringent requirement of the purchase order, the purchase order shall prevail. The purchase order requirements shall not take precedence if they, in any way, violate the requirements of the product specification or this specification; for example, by waiving a test requirement or by making a test requirement less stringent.
1.3 The requirements for introduction of new materials in specifications referencing this specification are given in Annex A1.
1.4 General requirements for flat-rolled stainless steel products other than bar are covered in Specification A480/A480M.
1.5 General requirements for wire products in coils are covered in Specification A555/A555M.
1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Military StandardsMIL-STD-129 Marking for Shipment and Storage MIL-STD-163 Preservation of Steel Products for Shipment (Storage and Overseas Shipment)
Other StandardPrimary Metals Bar Code Standard
A555/A555M Specification for General Requirements for Stainless Steel Wire and Wire Rods
A564/A564M Specification for Hot-Rolled and Cold-Finished Age-Hardening Stainless Steel Bars and Shapes
E139 Test Methods for Conducting Creep, Creep-Rupture, and Stress-Rupture Tests of Metallic Materials
Federal StandardsFed. Std. No. 123 Marking for Shipment (Civil Agencies) Fed Std. No. 183 Continuous Marking of Iron and Steel Products
ICS Number Code 77.140.20 (Steels of high quality)
UNSPSC Code 30260000(Structural materials); 30264500(Stainless steel bars)
ASTM A484 / A484M-12, Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings, ASTM International, West Conshohocken, PA, 2012, www.astm.orgBack to Top