ASTM A381-96(2005)

    Standard Specification for Metal-Arc-Welded Steel Pipe for Use With High-Pressure Transmission Systems

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 5 $50.40   ADD TO CART


    1. Scope

    1.1 This specification covers straight seam, double-submerged-arc-welded steel pipe (Note 1) suitable for high-pressure service, 16 in. (406 mm) and larger in outside diameter, with wall thicknesses from 5/16 to 1 1/2 in. (7.9 to 38 mm). The pipe is intended for fabrication of fittings and accessories for compressor or pump-station piping. Pipe ordered to this specification shall be suitable for bending, flanging (vastoning), corrugating, and similar operations.

    Note 1-A comprehensive listing of standardized pipe dimensions is contained in ANSI B36.10.

    Note 2-The term "double welded" is commonly used in the gas and oil transmission industry, for which this pipe is primarily intended, to indicate welding with at least two weld passes, of which one is on the outside of the pipe and one on the inside. For some sizes of the pipe covered by this specification, it becomes expedient to use manual welding, in which case the provisions of Note 3 shall be followed.

    1.2 Nine classes of pipe, based on minimum yield point requirements, are covered as indicated in Table 1.

    1.3 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate.

    1.4 The following hazard caveat applies to the test methods portion, Sections 9 and 10, only. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A530/A530M Specification for General Requirements for Specialized Carbon and Alloy Steel Pipe

    E30 Test Methods for Chemical Analysis of Steel, Cast Iron, Open-Hearth Iron, and Wrought Iron

    ASME Boiler and Pressure Vessel Code

    SectionIXWeldingQual


    ICS Code

    ICS Number Code 23.040.10 (Iron and steel pipes)

    UNSPSC Code

    UNSPSC Code 40171601(Industrial welded carbon steel pipe)


    DOI: 10.1520/A0381-96R05

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top