1. Scope
1.1 This specification covers austenitic and age-hardenable stainless steel round spring wire intended especially for the manufacture of springs.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 Unless the order specifies an “M” designation, the material shall be furnished to inch-pound units.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A555/A555M Specification for General Requirements for Stainless Steel Wire and Wire Rods
A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
Society of Automotive Engineers Standard
J1086 Numbering Metals and Alloys
Keywords
austenitic stainless steel; precipitation hardening stainless steel; stainless steel spring wire; Stainless steel wire--specifications; Steel springs--specifications; Steel wire--specifications; Steel wire (chromium alloy)--specifications;
ICS Code
ICS Number Code 77.140.25 (Spring steels)
DOI: 10.1520/A0313_A0313M-10
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
