ASTM A302/A302M-03(2007)

    Standard Specification for Pressure Vessel Plates, Alloy Steel, Manganese-Molybdenum and Manganese-Molybdenum-Nickel


      Format Pages Price  
    PDF 3 $45.60   ADD TO CART


    1. Scope

    1.1 This specification covers manganese-molybdenum and manganese-molybdenum-nickel alloy steel plates intended particularly for welded boilers and other pressure vessels.

    1.2 Plates under this specification are available in four grades having different strength levels as follows:

    GradeTensile Strength,
    ksi [MPa]
    Type
    A7595 [515655] manganese-molybdenum
    B80100 [550690]manganese-molybdenum
    C80100 [550690]manganese-molybdenum-nickel
    D80100 [550690]manganese-molybdenum-nickel

    1.3 The maximum thickness of plates is limited only by the capacity of the chemical composition to meet the specified mechanical property requirements. The minimum thickness is limited to 0.25 in. [6.5 mm].

    1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A20/A20M Specification for General Requirements for Steel Plates for Pressure Vessels

    A435/A435M Specification for Straight-Beam Ultrasonic Examination of Steel Plates

    A577/A577M Specification for Ultrasonic Angle-Beam Examination of Steel Plates

    A578/A578M Specification for Straight-Beam Ultrasonic Examination of Rolled Steel Plates for Special Applications


    ICS Code

    ICS Number Code 77.140.30 (Steels for pressure purposes); 77.140.50 (Flat steel products and semi-products)

    UNSPSC Code

    UNSPSC Code 30102204(Steel plate)


    Referencing This Standard

    DOI: 10.1520/A0302_A0302M-03R07

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM A302 / A302M-03(2007), Standard Specification for Pressure Vessel Plates, Alloy Steel, Manganese-Molybdenum and Manganese-Molybdenum-Nickel, ASTM International, West Conshohocken, PA, 2007, www.astm.org

    Back to Top