SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|2||$45.60||  ADD TO CART|
1.1 This specification covers manganese-silicon carbon steel plates for use in welded boilers and other pressure vessels.
1.2 Plates under this specification are produced in one grade only; however, the yield strength decreases on thicknesses over 1 in. [25 mm]:
|Tensile Strength,||Yield Strength,|
|Thickness||ksi [MPa]||ksi [MPa]|
|Up to 1 in.||75-95 [515-655]||42 |
|Over 1 in.||75-95 [515-655]||40 |
1.3 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements; however, current practice normally limits the maximum thickness of plates furnished under this specification to 8 in. [200 mm].
1.4 For plates produced from coil, the additional requirements, including additional testing requirements and the reporting of additional test results, of Specification A 20/A 20M apply.
1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A20/A20M Specification for General Requirements for Steel Plates for Pressure Vessels
A435/A435M Specification for Straight-Beam Ultrasonic Examination of Steel Plates
ICS Number Code 77.140.30 (Steels for pressure purposes); 77.140.50 (Flat steel products and semi-products)
UNSPSC Code 30102204(Steel plate)
ASTM A299 / A299M-97e1, Standard Specification for Pressure Vessel Plates, Carbon Steel, Manganese-Silicon, ASTM International, West Conshohocken, PA, 2001, www.astm.orgBack to Top