ASTM A299/A299M-01

    Standard Specification for Pressure Vessel Plates, Carbon Steel, Manganese-Silicon

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF Version 2 $44.40   ADD TO CART


    1. Scope

    1.1 This specification covers manganese-silicon carbon steel plates for use in welded boilers and other pressure vessels.

    1.2 Plates under this specification are produced in one grade only; however, the yield strength decreases on thicknesses over 1 in. [25 mm]:

    Tensile Strength,Yield Strength,
    Thickness ksi [MPa]ksi [MPa]
    Up to 1 in.75-95 [515-655] 42 [290]
    [25 mm]
    Over 1 in.75-95 [515-655] 40 [275]
    [25 mm]

    1.3 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements; however, current practice normally limits the maximum thickness of plates furnished under this specification to 8 in. [200 mm].

    1.4 For plates produced from coil, the additional requirements, including additional testing requirements and the reporting of additional test results, of Specification A 20/A 20M apply.

    1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A20/A20M Specification for General Requirements for Steel Plates for Pressure Vessels

    A435/A435M Specification for Straight-Beam Ultrasonic Examination of Steel Plates

    A577/A577M Specification for Ultrasonic Angle-Beam Examination of Steel Plates

    A578/A578M Specification for Straight-Beam Ultrasonic Examination of Rolled Steel Plates for Special Applications


    ICS Code

    ICS Number Code 77.140.30 (Steels for pressure purposes); 77.140.50 (Flat steel products and semi-products)

    UNSPSC Code

    UNSPSC Code 30102204(Steel plate )


    DOI: 10.1520/A0299_A0299M-01

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top