ASTM A291/A291M-05

    Standard Specification for Steel Forgings, Carbon and Alloy, for Pinions, Gears and Shafts for Reduction Gears

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 4 $44.40   ADD TO CART


    1. Scope

    1.1 This specification covers normalized and tempered carbon steel and quenched and tempered alloy steel forgings for pinions, gears, and shafts.

    1.2 Several grades of steel are covered as follows:

    1.2.1 Grade 1, Class A,is normalized and tempered carbon steel.

    1.2.2 Grade 2, Class B, Grade 3, Class C, Grade 3A, Class D, Grades 4 to 7, Classes E, F, G, and H, Grade 8, Class I, and Grade 9, Class J, are liquid quenched and tempered alloy steel.

    1.3 All grades and classes are considered weldable under proper conditions. Welding technique is of fundamental importance and it is presupposed that welding procedure and inspection shall be in accordance with approved methods for the class of material used.

    1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A275/A275M Practice for Magnetic Particle Examination of Steel Forgings

    A388/A388M Practice for Ultrasonic Examination of Steel Forgings

    A788/A788M Specification for Steel Forgings, General Requirements


    ICS Code

    ICS Number Code 77.140.85 (Iron and steel forgings)

    UNSPSC Code

    UNSPSC Code 31132100(Steel forgings)


    DOI: 10.1520/A0291_A0291M-05

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top