1.1 This specification covers high-strength low-alloy structural steel shapes, plates, and bars for welded, riveted, or bolted construction intended primarily for use as structural members where savings in weight [mass] or added durability are important. The atmospheric corrosion resistance of the steel in most environments is substantially better than that of carbon structural steels with or without copper addition. When properly exposed to the atmosphere, this steel can be used bare (unpainted) for many applications (see Note 1). This specification is limited to material up to 4 in. [100 mm], inclusive, in thickness.
Note 1—For methods of estimating the atmospheric corrosion resistance of low-alloy steels, see Guide G 101.
1.2 When the steel is to be welded, it is presupposed that a welding procedure suitable for the grade of steel and intended use or service will be utilized. See Appendix X3 of Specification A 6/A 6M for information on weldability.
1.3 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.4 For structural products produced from coil and furnished without heat treatment or with stress relieving only, the additional requirements, including additional testing requirements and the reporting of additional test results, of Specification A 6/A 6M apply.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A6/A6M Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling
G101 Guide for Estimating the Atmospheric Corrosion Resistance of Low-Alloy Steels
atmospheric corrosion resistance; bars; bolted construction; durability; high-strength; low-alloy; plates; riveted construction; shapes; steel; structural steel; weight; welded construction, Basic-oxygen steel; Corrosion-resistant steel--specifications; Corrosive service applications--bars/rods/shapes; Durability; HSLA (high-strength low-alloy) steel--specifications; Riveted construction--specifications; Steel bars--specifications; Structural steel (SS) bars--specifications; Structural steel (SS) plate--specifications; Structural steel (SS) shapes--specifications; Weight saving steel; Welded steel bars/shapes--specifications; Welded steel plate/sheet/strip--specifications;
ICS Number Code 77.140.10 (Heat-treatable steels)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]