ASTM A179/A179M-90a(1996)e1

    Standard Specification for Seamless Cold-Drawn Low-Carbon Steel Heat-Exchanger and Condenser Tubes

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 2 $44.40   ADD TO CART


    1. Scope

    1.1 This specification covers minimum-wall-thickness, seamless cold-drawn low-carbon steel tubes for tubular heat exchangers, condensers, and similar heat transfer apparatus.

    1.2 This specification covers tubes 1/8 to 3 in. [3.2 to 76.2 mm], inclusive, in outside diameter.

    Note 1—Tubing smaller in outside diameter and having a thinner wall than indicated in this specification is available. Mechanical property requirements do not apply to tubing smaller than 1/8 in. [3.2 mm] in outside diameter or with a wall thickness under 0.015 in. [0.4 mm].

    1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the "M" designation of this specification is specified in the order.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A450/A450M Specification for General Requirements for Carbon and Low Alloy Steel Tubes


    UNSPSC Code

    UNSPSC Code 40182300(Seamless steel tubes)


    DOI: 10.1520/A0179_A0179M-90AR96E01

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top