1. Scope
1.1 This specification applies to gray iron castings, cast in sand molds, used in the products of the automobile, truck, tractor, and allied industries.
1.2 The values stated in inch-pound units are to be regarded as the standard.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A247 Test Method for Evaluating the Microstructure of Graphite in Iron Castings
E10 Test Method for Brinell Hardness of Metallic Materials
Military Standard
MIL-STD-129 Marking for Shipment and Storage Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.
Federal Standard
Fed.Std.No.123 Marking for Shipment (Civil Agencies)
Keywords
automotive iron castings; automotive steel materials-structural; iron castings-gray; tractors; gray iron castings (used in products of automobile/truck/tractor/allied; industries);
ICS Code
ICS Number Code 77.140.80 (Iron and steel castings)
DOI: 10.1520/A0159-83R06
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
