1. Scope
1.1 This specification covers standard quality cold-finished carbon steel bars produced to chemical compositions. Standard quality cold-finished bars are suitable for heat treatment, for machining into components, or for use in the as-finished condition as shafting, or in constructional applications, or for other similar purposes (Note 1). Grades of steel are identified by grade numbers or by chemical composition.
Note 1-A guide for the selection of steel bars is contained in Practice A400. 1.2 Material furnished under this specification shall conform to the applicable requirements of the current edition of Specification A29/A29M.
1.3 Some end uses may require material superior to standard quality involving one or more of the available designations shown under Supplementary Requirements. Supplementary requirements shall apply only when specified individually by the purchaser.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A29/A29M Specification for Steel Bars, Carbon and Alloy, Hot-Wrought, General Requirements for
A304 Specification for Carbon and Alloy Steel Bars Subject to End-Quench Hardenability Requirements
A322 Specification for Steel Bars, Alloy, Standard Grades
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A400 Practice for Steel Bars, Selection Guide, Composition, and Mechanical Properties
A510 Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel
A576 Specification for Steel Bars, Carbon, Hot-Wrought, Special Quality
Other Documents
ISS Steel Bar Product Guidelines Available from ISS Customer Service, 410 Commonwealth Drive, Warrendale, PA, 15086.
Keywords
alloy steel; carbon steel; cold-finished; steel bar;
ICS Code
ICS Number Code 77.140.60 (Steel bars and rods)
DOI: 10.1520/A0108-99
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
