ASTM A1063/A1063M-11

    Standard Specification for Steel Sheet, Twin-Roll Cast, Zinc-Coated (Galvanized) by the Hot-Dip Process


      Format Pages Price  
    PDF 11 $58.80   ADD TO CART


    1. Scope

    1.1 This specification covers steel sheet, produced by the Twin-Roll Cast Process (see Appendix X2) and zinc-coated (galvanized) by the hot-dip process in coils and cut lengths.

    Note 1—See Appendix X2 for a description of the Twin-Roll Cast process.

    1.2 The product is produced in various zinc coating weights [masses] or coating designations as shown in Table 1.

    1.3 Product furnished under this specification shall conform to the applicable requirements of the latest issue of Specification A924/A924M unless otherwise provided herein.

    1.4 The product is available in a number of designations, grades and classes and in the two following general categories that are designed to be compatible with different application requirements.

    1.4.1 Steels with mandatory chemical requirements and typical mechanical properties.

    1.4.2 Steels with mandatory chemical requirements and mandatory mechanical properties.

    1.5 This material is available in the following sizes:

    1.5.1 Thicknessup to 0.078 in. [2.0 mm]

    1.5.2 Widthup to 79 in. [2000 mm]

    1.6 The text of this specification references notes and footnotes that provide explanatory material. These notes and footnotes, excluding those in tables and figures, shall not be considered as requirements of this specification.

    1.7 This specification is applicable to orders in either inch-pound units (as A1063) or SI units (as A1063M). Values in inch-pound and SI units are not necessarily equivalent. Within the text, SI units are shown in brackets. Each system shall be used independently of the other.

    1.8 Unless the order specifies the M designation (SI units), the product shall be furnished to inch-pound units.

    1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A90/A90M Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy Coatings

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A568/A568M Specification for Steel, Sheet, Carbon, Structural, and High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for

    A902 Terminology Relating to Metallic Coated Steel Products

    A924/A924M Specification for General Requirements for Steel Sheet, Metallic-Coated by the Hot-Dip Process


    ICS Code

    ICS Number Code 77.140.50 (Flat steel products and semi-products)

    UNSPSC Code

    UNSPSC Code 30264000(Carbon steel sheets)


    Referencing This Standard

    DOI: 10.1520/A1063_A1063M-11

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM A1063 / A1063M-11, Standard Specification for Steel Sheet, Twin-Roll Cast, Zinc-Coated (Galvanized) by the Hot-Dip Process, ASTM International, West Conshohocken, PA, 2011, www.astm.org

    Back to Top