ASTM A1039/A1039M-11

    Historical Standard: ASTM A1039/A1039M-11 Standard Specification for Steel, Sheet, Hot Rolled, Carbon, Commercial, Structural, and High-Strength Low-Alloy, Produced by Twin-Roll Casting Process

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    8 pages
    $50.40

    Active (view current version of standard)


    ASTM A1039 / A1039M

    1. Scope

    1.1 This specification covers commercial and structural steel sheet in coils and cut lengths produced by the twin-roll casting process.

    1.2 The steel sheet is available in the designations listed in Section 4.

    1.3 The material is available in the following sizes:

    Thickness0.027 in. [0.7 mm] to 0.078 in. [2.0 mm]
    Widthup to 79 in. [2000 mm]

    1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    Note 1—A description of the Twin-Roll Casting Process is included in Appendix X1.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A568/A568M Specification for Steel, Sheet, Carbon, Structural, and High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for

    A941 Terminology Relating to Steel, Stainless Steel, Related Alloys, and Ferroalloys


    ICS Code

    ICS Number Code 77.140.01 (Iron and steel products in general)

    UNSPSC Code

    UNSPSC Code 30264000(Carbon steel sheets)


    DOI: 10.1520/A1039_A1039M-11

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top