1. Scope
1.1 This specification covers commercial and structural steel sheet in coils and cut lengths produced by the twin-roll casting process.
1.2 The steel sheet is available in the designations listed in Section 4.
1.3 The material is available in the following sizes:
| Thickness—0.027 in. [0.7 mm] to 0.078 in. [2.0 mm] |
| Width—up to 79 in. [2000 mm] |
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Note 1—A description of the Twin-Roll Casting Process is included in Appendix X1.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A568/A568M Specification for Steel, Sheet, Carbon, Structural, and High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for
A941 Terminology Relating to Steel, Stainless Steel, Related Alloys, and Ferroalloys
Keywords
as-cast sheet; carbon steel sheet; commercial steel; high-strength low-alloy steel; hot rolled steel sheet; steel sheet; structural steel; Carbon steel sheet--specifications; High-strength low-alloy (HSLA) steel; Hot-rolled carbon steel; Steel sheet; Twin-roll casting
ICS Code
ICS Number Code 77.140.01 (Iron and steel products in general)
DOI: 10.1520/A1039_A1039M-09
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
