Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM A1034/A1034M-05

Standard Test Methods for Testing Mechanical Splices for Steel Reinforcing Bars

Standard Test Methods for Testing Mechanical Splices for Steel Reinforcing Bars A1034_A1034M-05 ASTM|A1034_A1034M-05|en-US Standard Test Methods for Testing Mechanical Splices for Steel Reinforcing Bars Standard new BOS Vol. 01.04 Committee A01
$ 75.00 In stock

Scope

1.1 These test methods cover the testing of mechanical splices for reinforcing bars. The various tests herein described can be specified in total or individually.

1.2 The test methods herein described are applicable to any type of mechanical splice manufactured to join steel reinforcing bars of any grade (specified minimum yield strength), uncoated or coated.

1.3 This standard describes only the methods for testing mechanical splices for steel reinforcing bars, but does not quantify the parameters for testing nor acceptance criteria, which must be specified by the purchaser.

Note 1—Various code-writing bodies specify various parameters, such as test loads, number of cycles and test temperature, for testing.

1.4 The values stated in either SI or inch-pound units are to be regarded as standard. Within the text, the inch-pound units are shown in parentheses. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.04
Developed by Subcommittee: A01.05
Pages: 5
DOI: 10.1520/A1034_A1034M-05
ICS Code: 77.140.50