ASTM A1030/A1030M-05

    Historical Standard: ASTM A1030/A1030M-05 Standard Practice for Measuring Flatness Characteristics of Steel Sheet Products

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    11 pages
    $57.60

    Active (view current version of standard)


    ASTM A1030 / A1030M

    1. Scope

    1.1 Flatness is a significant quality characteristic of steel sheet products. Sheet flatness is affected by mill process factors plus the grade, thickness and width of the material supplied. It is the purpose of this practice to define the different flatness characteristics and to describe the method(s) most commonly used to measure particular characteristics. The methods described are designed and intended to be used in mill situations and environments.

    1.2 The substrate shall conform to all the requirements of the appropriate specifications as follows: Specifications A 568/A 568M or A 924/A 924M.

    1.3 Quantitative limits are not addressed and are established in the general requirements, or individual product specifications, or both; or when applicable, as agreed to between supplier and user.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A568/A568M Specification for Steel, Sheet, Carbon, Structural, and High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for

    A924/A924M Specification for General Requirements for Steel Sheet, Metallic-Coated by the Hot-Dip Process


    ICS Code

    ICS Number Code 17.040.30 (Measuring instruments)

    UNSPSC Code

    UNSPSC Code 30264000(Carbon steel sheets)


    DOI: 10.1520/A1030_A1030M-05

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top