ASTM A1014/A1014M-06

1. Scope

1.1 This specification covers a precipitation hardening bolting material (UNS N07718) for high temperature service.

1.2 This specification is expressed in both inch-pound and in SI units. However, unless the order specifies the applicable "M" designation (SI units), the material shall be furnished to inch-pound units.

1.3 The values stated in either inch-pounds or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A370 Test Methods and Definitions for Mechanical Testing of Steel Products

A962/A962M Specification for Common Requirements for Bolting Intended for Use at Any Temperature from Cryogenic to the Creep Range

B637 Specification for Precipitation-Hardening and Cold Worked Nickel Alloy Bars, Forgings, and Forging Stock for Moderate or High Temperature Service

B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys

E112 Test Methods for Determining Average Grain Size

E292 Test Methods for Conducting Time-for-Rupture Notch Tension Tests of Materials

ASME Standards

SAE Standards

ICS Code

ICS Number Code 77.140.30 (Steels for pressure purposes)

DOI: 10.1520/A1014_A1014M-06

ASTM International is a member of CrossRef.

Citing ASTM Standards

[Back to Top]