ASTM A1013-00

    Standard Test Method for High-Frequency (10 kHz-1 MHz) Core Loss of Soft Magnetic Core Components at Controlled Temperatures Using the Voltmeter-Ammeter-Wattmeter Method


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART


    1. Scope

    1.1 This test method covers the equipment, procedures, and measurement of core loss of either toroidal or mated soft magnetic core components, such as soft ferrite cores, iron powder cores, and so forth, over ranges of controlled ambient temperatures typically from -20 to +120oC, frequencies from 10 kHz to 1 MHz, under sinusoidal flux conditions.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    1.2 The values and equations stated in customary (cgs-emu and inch-pound) of SI units are to be regarded separately as standard. Within this test method, SI units are shown in brackets except for the sections concerning calculations where there are separate sections for the respective unit systems. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A34/A34M Practice for Sampling and Procurement Testing of Magnetic Materials

    A340 Terminology of Symbols and Definitions Relating to Magnetic Testing

    E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods


    ICS Code

    ICS Number Code 29.100.10 (Magnetic components)

    UNSPSC Code

    UNSPSC Code 31380000(Magnets and magnetic materials)


    Referencing This Standard

    DOI: 10.1520/A1013-00

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM A1013-00, Standard Test Method for High-Frequency (10 kHz-1 MHz) Core Loss of Soft Magnetic Core Components at Controlled Temperatures Using the Voltmeter-Ammeter-Wattmeter Method, ASTM International, West Conshohocken, PA, 2000, www.astm.org

    Back to Top