ASTM A1010/A1010M-01(2009)

    Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet , and Strip


      Format Pages Price  
    PDF 2 $45.60   ADD TO CART


    1. Scope

    1.1 This specification covers martensitic stainless steels for various structural, architectural, pressure vessel, and heat-resisting applications. The mechanical properties of these steels are customarily, but not necessarily, developed by a suitable heat treatment generally referred to as tempering.

    1.2 Steel products under this specification are available in two grades:

    GradeYield Strength, min, ksi [MPa]
    40 [275]40 [275]
    50 [350]50 [350]

    1.3 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements; however, current practice normally limits the maximum thickness of plates furnished under this specification to 1 in. [25 mm].

    1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A480/A480M Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip

    A673/A673M Specification for Sampling Procedure for Impact Testing of Structural Steel

    E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)

    Other Document

    SAEJ1086 Recommended Practice for Numbering Metals and Alloys Available from Society of Automotive Engineers (SAE), 400 Commonwealth Dr., Warrendale, PA 15096-0001, http://www.sae.org.


    ICS Code

    ICS Number Code 77.140.01 (Iron and steel products in general)

    UNSPSC Code

    UNSPSC Code 30102205(Stainless steel plate)


    Referencing This Standard

    DOI: 10.1520/A1010_A1010M-01R09

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM A1010 / A1010M-01(2009), Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet , and Strip, ASTM International, West Conshohocken, PA, 2009, www.astm.org

    Back to Top