Technical Committees / Committee E28 / Committee Publications

Publications Sponsored by Committee E28 on Mechanical Testing:

Annual Book of ASTM Standards

• Volume 03.01 Metals -- Mechanical Testing; Elevated and Low-Temperature Tests; Metallography

Special Technical Publications (STPs)

• STP 1476 Pendulum Impact Machines: Procedures and Specimens
• STP 1380 Pendulum Impact Testing: A Century of Progress
• STP 1304 M3D III: Mechanics and Mechanisms of Material Damping
• STP 1248 Pendulum Impact Machines: Procedures and Specimens for Verification
• STP 1208 Automation of Mechanical Testing
• To see complete list, click here.

Adjuncts

• Adjunct to E208 Test Method for Conducting Drop-Weight Test to Determine Nil-Ductility Transition Temperature of Ferritic Steels

Related Journal Papers:

Journal of ASTM International

• Study of an On-Line Crack Compliance Technique for Residual Stress Measurement Using 2D Finite Element Simulations of Fatigue Crack Growth
• Testing Damping Performance and Bending Stiffness of Snowboarding Wrist Protectors
• Correlation Between Charpy Absorbed Energy Using 2 mm and 8 mm Strikers
• Evaluation of Bias for Two Charpy Impact Machines with the Same Instrumented Striker
• Finite Element Modeling of a Rockman Portable Dynamic Hardness Tester
• To see complete list, click here.

Geotechnical Testing Journal

• Triaxial Testing of Soft Rocks

Journal of Testing and Evaluation

• Computation and Uncertainty Evaluation of Offset Yield Strength
• Effect of Electrical Discharge Machining (EDM) on Charpy Test Results from Miniaturized Steel Specimens
• Computation of Tensile Strain-Hardening Exponents through the Power-Law Relationship
• In-Plane Testing Behavior of Adhesive-Bonded Steel Sheets: Influence of Sheet Surface Roughness, Adhesive Thickness, and Bonding Width
• Test System for Elevated Temperature Characterization of Thin Metallic Sheets
• To see complete list, click here.

Journal of Materials Performance and Characterization (MPC)

• Modeling of Distortion during Casting and Machining of Aluminum Engine Blocks With Cast-in Gray Iron Liners
• Effect of Cyclic Strain on Mechanical Behavior of Structural Steels in Room and Low Temperatures
• Formability and Microstructural Characterization of Sintered Powder Metallurgical Preforms of Dual-Phase Steel